[WVDXA] The Further Antenna Adventures of W8TN

[W8TN - Clark]

Well, as a couple of you know, I busted my tail this week to try and get up
a 160-M Inverted "L" antenna for the CQ Contest this weekend.  I spent the
Phone contest on 80-M but with only the 80-M antenna currently up, I thought
I'd like to give 160-M a try during the CW weekend.

Pictures describing the antenna construction can be found here: <
http://w8tn.com/Gallery/Tower>  Begin with the second photo with the text
"19 November I gathered the materials . . ."

What is NOT shown there is the PAIN I suffered.  It took three trips up the
tower, staying on the tower one night till 45 minutes after sundown, and an
uncounted number of trips through the woods behind my house.  Working by
myself caused me to have to come up with some inventive ways to do the
project.  All this resulted in many bruises, scrapes, abrasions, and a
pulled muscle in my side which has caused me the biggest problem.  Why is it
that little projects like this cause so much trouble when you are nearly 60
years old?

First I had to gather the materials.  This involved a trip to Home Depot and
then the Water Company.  I needed to construct an RF choke (several turns of
coax) and I found a description in the ARRL Antenna Book of one using 30
turns of RG-213 on an 8-inch diameter piece of PVC.  Turns out Home Depot
doesn't have anything that large but the Water Company graciously gave me a
6-foot piece.  So if anyone needs some 8-inch PVC, I have almost 5-feet
left.

To get the antenna to come off the tower horizontally at 60-feet above
ground requires putting a line over a tall tree or two to support the
antenna wire.  The EZ Hang <http://www.ezhang.com/> slingshot with spinning
reel which I have used several times in the past, failed me.  I had
installed a new set of elastic tubing bands and a new roll of fishing line
but, for some reason, I could not keep from snagging the line in the elastic
bands when trying to launch it from the ground.  So, after 6 or 7 failures
to launch the line, I had to climb the tower and hang off the side to launch
the line over a couple of trees.  This time it worked!  So, I climbed down,
trekked through the woods and tied the fishing line to some Dacron antenna
support line (note the Boy Scout method I used to let the line unroll freely
in one of the pictures linked above.)  Back at the tower I reeled in the
line and attached it to the antenna.  Then, off through the woods to pull
the antenna up and check the SWR with an MFJ-259B Antenna Analyzer.

Imagine my disappointment when the antenna showed an infinite SWR!  I was
crushed.  Three days of difficult work seemed lost.  So, I checked
everything I could then I called W8DL.  Don was shocked that it did not work
as my dimensions were nearly the same as his.  However, his antenna played
against a conventional ground radial system and I was trying the "quick and
dirty" single elevated radial for my installation.  He suggested either
removing the RF Choke or modifying the radial system.  But, I was short on
time and did not feel I could get a good enough ground installed before the
contest.

I then called my 160-M guru, KØCS, and he was stumped as well.  However, he
did comment that the dimensions I was using (straight out of the ARRL
Antenna Book) seemed a bit too long for him.  He suggested that I cut
30-feet off the radial and see what happened.  Then, I could lower the
vertical radiator and cut some off it until a match was found..

So, on Friday (the day the contest started) I braved the 30-degree
temperatures and climbed down the hill with my tools.  As I was going over
the hill Evelyn yelled down that KØCS had called and said to try moving the
antenna further away from the tower.  So, I tried that and found a bit of an
improvement but only a negligible amount.  Then I hiked out to the end of
the radial and cut off 30-feet.  Back at the tower the MFJ-259 Analyzer said
I had made a nice change in the resonant frequency but not enough by far.
So, back through the woods to attach the roll of Dacron to the end of the
vertical radiator.  NOTE:  Here is where I made a crucial mistake!  It was
cold, snowing, and windy and my brain failed to realize that when I pulled
the antenna back up, the end I was tying the line to now would be up in the
air.  I mistakenly thought I would only need a temporary knot on the
Dacron.  WRONG!

Then, back to the tower and up I went.  At the 60-foot level I carefully
pulled in the 110-feet of the radiator tophat and, while hanging on the
tower in the wind, measured and cut off 30-feet.  I then carefully arraigned
the wire so it would not snag and went down the tower and out through the
woods.  I then proceeded to pull up the antenna.  When I thought I almost
had it to the end, it seemed to snag and I gave a little more pressure to
the Dacron line and suddenly it went slack.  Yep, the "temporary" knot had
untied and the end of the antenna support line was 20-feet in the air!
RATS!  All this work and now the antenna was at the mercy of the wind and
roosting birds.  The slightest thing would cause it to fall.  And, I had
snagged the fishing line and could not use the slingshot (if it would even
work again!)  Needless to say, I was bummed out!

But, I carefully wound the Dacron back on the reel and trudged dejectedly
back to the tower.  I put the MFJ on the antenna and VOILA!  It was now
resonant at 1.75 MHz.  Close enough to 160-M that it just might work.

To try and salvage some of this work I climbed back up to the house and
quickly installed a vacuum variable capacitor in a plastic can and took it
back over the hill.  Tuning the capacitor to the end stop resulted in an SWR
of 1.7:1 from 1.800 to 1.820 MHz, 1.8:1 at 1.825 MHz and 2.0:1 at
1.835MHz.  Maybe, just maybe, this could work.

So, I wearily pulled my aching body back up the hill and fired up the amp.
Yep, it would put out 1,000 watts up to 1.835 Mhz. with no difficulty.  So,
I fired up the laptop computer for logging and got ready to start the
contest in just 45 minutes!  That's cutting it close.

As they say, the proof is in the pudding (or the QSO's.)  In my 43 years of
ham radio, I had dabbled at 160-M a time or two but never had a decent
antenna.  My country total for that entire 43 years stands at just 23
countries confirmed.  However, this weekend, I added TWENTY-NINE (29) NEW
Countries and 7 NEW Zones to my totals!  WOW!  Am I excited now?  Yep!

Here is my contest score:

        Band    QSOs    Pts  Cty   ZN
         1.8        71       162   38    15

Final Score: 8,586

Bear in mind I was not trying for a contest "score" but only seeing if I
could work some new countries.  Well, I sure did.  I even stayed up that
first night until 7:30 a.m. and tried for over 1/2 hour to work a JA.  I
heard him really quite well but he never got a peep from me.  I did manage 5
continents and only missed Asia for a WAC my first night on the band from
the new QTH.  And, that was with no receiving antennas and not very good
conditions.

New countries worked (that I had never worked before on 160-M were:  CN, CM,
PJ5, VE (Yep, never worked Canada before), HR, J3, KV4, EA, SV (Zone 20 !),
FJ/FS, 3X, G, SM, OM, ZF, SP, OK, XE, V4, HC8, YN, GW, FM, 6Y, YS, VP2M,
EA6, V2, and, LX.  NEW Zones were: 33, 20, 02, 35, 15, 06, and 10.

If the birds and the wind will just leave the wire alone for a few months
I'll have some more fun on the band.  If not, it looks like more work to get
the antenna tuned better and then back up over the trees.  But, at least I
proved the concept.


Clark, W8TN
*Working Toward 160-M DXCC*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://wvdxa.org/pipermail/wvdxa_wvdxa.org/attachments/20071125/f7e4b90c/attachment.html